How To Reset Maintenance Light On 2008 Toyota Tundra

The service manager re-set it but will not show me how to do it.

How to reset maintenance light on 2008 toyota tundra. Select MAINTENANCE RESET Press the center button to select Select YES When a confirmation message appears select YES to accepting the maintenance reset. The Maintenance Required light will be reset. Maintenance Reset Is Complete.

Turn your key to the off notch. The instructions below tell you how to reset your oil change light aka maintenance light on your 2007 or newer Toyota Tundra. Do not go as far as to start the engine.

This is best done after any repair work to. Push and hold down the ODO button and push the Power button twice with your foot off the brake. Make sure the Trip A is reading on the odometer.

All you have to do is remove the positive terminal on your. For some models this is the button used to switch from the odometer reading to the other two trip 3. Press and hold the odometer button.

When replacing sensors and performing maintenance on a Toyota Tundra the engine control unit may not turn the indicator light off. STEP 5 Turn The Ignition OFF. To reset the oil maintenance light press the display until it reads the odometer reading turn the power switch off press the power switch to ignition on while holding down the trip meter reset button keep the trip reset button held down for about 10 seconds the display will read 000000 and then the light will go.

Press and hold the Trip button. While holding the knob turn the key back to the on notch. Wait for the system to reset.